8 stabil-trak™ system test, 1 stabil-trak™ system test instructions, 2 stabil-trak™ system test procedures – SkyTrak 8042 Service Manual User Manual
Page 861: Stabil-trak™ system test, Section 10.8, “stabil-trak™ system test, Stabil-trak™ system test 10.8.1, Stabil-trak™ system test instructions, Stabil-trak™ system test procedures, Section 10.8, “stabil-trak™ system test,” fo, E section 10.8, “stabil-trak™ system test
![background image](/manuals/546131/861/background.png)
Stabil-TRAK™ System and Boom Interlock System
10.20
Model 8042, 10042, 10054 Legacy
Rev. 10/03
10.8
STABIL-TRAK™ SYSTEM TEST
IMPORTANT: The operator must know that the
Stabil-TRAK™ system is active and functioning properly.
To test the function of the Stabil-TRAK™ system, read
the Stabil-TRAK™ System Test instructions and follow
Steps 1 through 9 of Section 10.8.2, “Stabil-TRAK™
System Test Procedures.”
10.8.1
Stabil-TRAK™ System Test
Instructions
• Test the Stabil-TRAK™ system with the vehicle
on a level surface.
• Remove any attachment from the quick attach
before performing the test.
• DO NOT extend the boom at any time during the
test. Perform the test with the boom fully retracted.
• DO NOT raise the boom above 60° for Steps 3-6.
• DO NOT raise the boom above 45° for Steps 7-9.
• Follow Steps 1 through 9 of the Stabil-TRAK™
system test procedure exactly as written.
IMPORTANT: If the Stabil-TRAK™ light goes OFF and
the front left tire lowers to the ground at any time during
Steps 4 through 7, the test was not performed properly
or the Stabil-TRAK™ system is not functioning properly.
Carefully repeat the steps starting with Step 1.
If the Stabil-TRAK™ light goes OFF and the front left tire
lowers to the ground consistently during Steps 4 through 7,
the Stabil-TRAK™ system is not functioning properly and
the test should be stopped immediately. If the Stabil-
TRAK™ system is not functioning properly, follow the
procedures in Section 10.12, “Stabil-TRAK™ Hydraulic
Circuit Operation and Troubleshooting,” to repair the
system.
10.8.2
Stabil-TRAK™ System Test
Procedures
If Steps 1 through 9 prove positive, the Stabil-TRAK™
system is functioning properly, and the vehicle can be
returned to service. If any of these steps indicate that the
Stabil-TRAK™ system is not functioning properly, follow
the procedures in Section 10.12, “Stabil-TRAK™ Hydraulic
Circuit Operation and Troubleshooting,” to repair the
system.
WARNING:
DO NOT operate this vehicle
unless you are in the seat with the seat belt
fastened around you. Death or serious
personal injury could result if the belt is not
securely fastened.