SkyTrak 8042 Service Manual User Manual
Page 358
7A.35
Model 8042, 10042, 10054 Legacy
Rev. 10/03
Engine: Cummins 4BT3.9 and 4BTA3.9
17. Connect the alternator ground wire (16), D+ (17) and
B+ (18) harness wire leads.
18. Position the starter (19) in its mounting opening on
the flywheel housing. Position the ground cable (20)
over the lower starter bolt. Secure the starter with
12-point fasteners (21). Torque fasteners to 32 lb-ft
(43 Nm).
19. Install the red, positive (+) battery cable (22) and two
red wires (23) to the upper solenoid stud (24). Install
a lockwasher and nut on stud, and finger tighten. DO
NOT connect the negative (-) lead at this time.
20. Install the blue/orange wire (25) to the solenoid
mounting stud (26). Install a lockwasher and nut to
the stud. Torque to 3.4 lb-ft (4,6 Nm).
21. Install Starter and Connect Wires to the Starter.
MH5580
13
14
15
B+
D+
D-
ORG
BLK
YEL
2W
G
6
38
5
RED
MA8400
16
17
18
MA8420
19
20
21
22
23
24
25
26