SkyTrak 8042 Service Manual - Manual (Page 68)

3.7 Model 8042, 10042, 10054 Legacy Rev. 03/04
Boom
13. Without optional auxiliary hydraulics: Inside the
inner boom, remove the two capscrews (15) and two
lockwashers (16) holding the stack clamps (17) to
the left side wall of the inner boom. Remove the
clamp cover plate (18) and all the clamps.
14. Pull the free ends of the Attachment Tilt hoses (19)
and (optional) auxiliary hydraulic hoses (20) from
inside the inner boom and out the rear of the
boom (21). Allow the hoses to hang from the rear of
the boom.
15. At the front of the intermediate boom (22), remove
the capscrews (23) and lockwashers (24) holding the
top wear pads (25) and spacers (26) to the inside of
the intermediate boom. Label the wear pads and
spacers as “Top Left” and “Top Right” sides. Save
the spacers, capscrews, lockwashers and wear pad
inserts (27).
16. At the front of the intermediate boom (28), remove
the capscrews (29), lockwashers (30) and flat
washers (31) holding the side wear pads (32) and
shims (33) to the inside of the intermediate boom.
Label the wear pads and shims as “Left Upper/Lower”
and “Right Upper/Lower.” Save the shims, capscrews,
flat washers, lockwashers and wear pad inserts (34).
MH0860
15
16
17
18
MH0870
19
20
21
20
MH0890
22
23
24
25
26
27
24
MH0900
28
29
30 31
32
33
34