SkyTrak 8042 Service Manual - Manual (Page 789)

Electrical System
9.198 Model 8042, 10042, 10054 Legacy Rev. 10/03
f. Starter Installation
Applies To Serial Numbers: 8042, 13198 - 18990,
10042 13198 - 19030, 10054, 13198 - 19079
1. Position the starter (1) in its mounting opening on
the flywheel housing. Position the ground cable (2)
over the correct starter mounting bolt (3). Secure the
starter with the three fasteners (3). Torque fasteners
to 32 lb-ft (43 Nm).
2. Connect the red, positive (+) battery cable (4) to the
upper solenoid stud (5). Install the two red wires (6)
to the upper solenoid stud, and secure with
lockwasher and nut. Torque nuts to 3.4 lb-ft
(4,6 Nm).
3. Connect the blue/orange wire (7) to the solenoid
mounting stud.
Applies To Serial Numbers: 8042, 18991 - 19987,
10042 19031 - 19987, 10054, 19080 - 19987 And
8042/10042/10054, 0160002332 & After
1. Position the starter (8) in its mounting opening on
the flywheel housing. Secure the starter with two
fasteners (9). Torque fasteners to 32 lb-ft (43 Nm).
2. At the negative starter stud (10), connect the
negative (-) battery cable (11). Torque mounting
hardware to 3.7 lb-ft (5 Nm).
3. Connect the positive (+) battery cable (12) and
starter positive buss bar (13), with the wires (14) still
connected, at the positive starter stud (15). Torque
mounting hardware to 3.7 lb-ft (5 Nm).
MA8420
1
2
3
4
5
6
7
SN 8042, 13198 - 18990, 10042 13198 - 19030,
10054, 13198 - 19079
MH5680
SN 8042, 18991 - 19987, 10042 19031 - 19987,
10054, 19080 - 19987 And
8042/10042/10054, 0160002332 & After
8
9
8
9
15
12
13
14
10
11