SkyTrak 8042 Service Manual - Manual (Page 742)

9.151 Model 8042, 10042, 10054 Legacy Rev. 10/03
Electrical System
Repair/replace
roadlight harness.
Replace brake
switch.
Repair/replace
roadlight harness.
Replace bulb.
If one brake light is not
ON with the brake pedal
depressed, verify voltage
at that brake light
connector, wires
[2E] & [26A] (Left Rear) or
[2F] & [26B] (Right Rear).
Check for voltage at brake
pedal switch Pin 4,
wire [1D] (RED).
Check for voltage at
brake pedal switch
Pin 5, wire [26]
With the ignition ON and
the brake pedal depressed,
brake lights remain OFF.
Before troubleshooting any
electrical circuit, ALWAYS
begin by checking the
following:
1. Fuses.
2. All connections relating
to circuit are clean and
tight.
3. Before troubleshooting
the brake lights circuit,
verify that the worklight
circuit is operating. If
not, follow the steps
listed at, Section 9.7.53,
“Roadlights w/
Worklights Circuit and
Troubleshooting
(Option),” before
troubleshooting the
brake lights circuit.
If OK
Not
OK
Not OK
Not OK If OK
If OK