SkyTrak 8042 Service Manual - Manual (Page 794)

9.203 Model 8042, 10042, 10054 Legacy Rev. 10/03
Electrical System
b. Alternator Installation
1. Position the alternator and align with the upper
alternator mount (7) on the engine bracket. Insert
the upper (longer) mounting hardware (6) through
the alternator mount. Thread the longer capscrew
into the alternator front mount. DO NOT tighten
completely at this time.
2. Align the lower alternator mount hole (5) with the
lower mounting bracket on the engine, and insert the
lower mounting capscrew (4). Tighten the lower
capscrew (4) and upper capscrew (6) securely.
Applies To Serial Numbers: 8042, 13198 - 18990,
10042 13198 - 19030, 10054, 13198 - 19079
3. At the rear of the alternator, connect the alternator
ground wire (8), D+ (9) and B+ (10) wire leads.
Applies To Serial Numbers: 8042, 18991 - 19987,
10042 19031 - 19987, 10054, 19080 - 19987 And
8042/10042/10054, 0160002332 & After
4. At the rear of the alternator, connect the alternator
wires:
• AG1 and AG2 to G terminal (1)
• AB1 and AB2 to B+ terminal (2)
• 38 and 6 to D+ terminal (2)
Applies To All Vehicles
5. Place a 1/2" square drive ratchet into the square
hole (11) on the tensioner bracket (12). Apply
pressure against the tensioner bracket (12) and
route the fan belt (13) onto the alternator and engine
pulleys. Release and check the tensioner pulley to
verify that it is pivoting freely in order to provide the
proper tension on the belt. Check for proper fan belt
deflection. (Refer to the appropriate Legacy Owners/
Operators Manual.)
B+
D+
D-
ORG
BLK
YEL
2W
G
6
38
5
RED
MA8400
8
9
10
MT1840
11
12
13
SN 8042, 13198 - 18990, 10042 13198 - 19030,
10054, 13198 - 19079
MH4560
11
12
13
SN 8042, 18991 - 19987, 10042 19031 - 19987,
10054, 19080 - 19987 And
8042/10042/10054, 0160002332 & After