SkyTrak 8042 Service Manual - Manual (Page 228)

3.167 Model 8042, 10042, 10054 Legacy Rev. 03/04
Boom
34. Assemble the left auxiliary hydraulic hose (17)
labeled “Female Coupler” from inside the gooseneck
to the female coupler (18) bulkhead fitting. Tighten
securely.
35. Assemble the right auxiliary hydraulic hose (19)
labeled “Male Nipple” from inside the gooseneck to
the male nipple (20) bulkhead fitting. Tighten
securely.
36. Adjust the inner boom extend and retract chains.
(Refer to the Section 3.7.5, “Inner Boom Chain
Tension Adjustment.”)
37. After adjustment is complete, assemble the rear
cover to the rear of the outer boom. On the rear of
the outer boom (21), position the rear cover (22) in
place. Secure the cover with the flat washer (23),
saved, internal-tooth lockwasher (24), saved, and
thumbscrew (25), saved. Insert the thumbscrew
through the bottom of the outer boom and into the
rear cover. Tighten the thumbscrew securely.
MH1760
13
14
15
16
MH0840
17
18
19
20
MH0850
21
22
23
24
25