SkyTrak 8042 Service Manual - Manual (Page 589)

Hydraulic System
8.174 Model 8042, 10042, 10054 Legacy Rev. 10/03
f. Side Tilt Carriage Cylinder Installation
1. Install the side tilt carriage cylinder (2) onto the side
tilt carriage (1). Secure the rod end to the side tilt
carriage with the cylinder rod pin (6) and snap rings
(4). Secure the tube end to the pivot base (7) with
the cylinder base pin (5) and snap rings (4).
2. Lubricate the pivot pins (5 and 6) with multi-purpose
grease.
3. Remove all plugs and caps from the hydraulic lines
(3) and securely tighten the lines to the cylinder.
4. Start the engine and remove any blocking from the
carriage.
5. Tilt the side carriage five times through its full range
or until operation of the side tilt carriage is normal
(no jerks or spongy feel).
6. Shut the engine OFF. Check the hydraulic level and
fill as required.
MT1950
1
2
3
4
5
6
7
4
4
WARNING:
Escaping hydraulic fluid
under pressure can penetrate the skin, causing
death or serious injury.
WARNING:
Avoid prolonged engine
operation in closed areas with inadequate
ventilation. Failure to properly ventilate exhaust
fumes can result in death or serious injury.