SkyTrak 8042 Service Manual - Manual (Page 247)

Cab and Covers
4.8 Model 8042, 10042, 10054 Legacy Rev. 10/03
9. Working through the right dash panel opening, label,
disconnect and plug the load sense hose (1) at the top
of the steering valve. Cap the fitting on the steering
valve.
10. Disconnect the horn button wire (2) from the cab
wiring harness.
11. Support the bottom of the steering valve (3), and
remove the four hex-flange capscrews (4) and four
lockwashers (5). Remove the steering valve through
the lower dash panel opening.
12. Remove the steering column (6), by pushing it down,
and removing it through the lower dash panel
opening.
b. Steering Column and Valve Installation
1. Install the steering column (6) and steering valve (3),
by inserting them through the lower dash panel
opening. Position steering valve in the cab, with the
“LS” port (7) pointing forward (away from the operator).
Secure the steering valve and column with four hex-
flange capscrews (4) and four lockwashers (5).
Torque capscrews to 13 lb-ft (18 Nm).
Note: ALWAYS use new o-rings when servicing the
vehicle.
2. Install new o-rings into the fittings. Lubricate the o-rings
with clean hydraulic oil.
3. Connect the load sense hose (1) to the “LS” port at
the top of the steering valve.
4. Connect the horn button wire (2) to the cab wiring
harness.
MA8680
1
2
MA8860 3
4
5
6
7