Electrical system – SkyTrak 8042 Service Manual User Manual
Page 716
9.125
Model 8042, 10042, 10054 Legacy
Rev. 10/03
Electrical System
Not
OK
Disconnect both connectors at
the steer select valve solenoids,
wires [8], [2C] and [9], [2B].
Check for front-wheel steer
Front-wheel steer mode
does not function when the
steer select switch is in the
center position
Refer to Section 8.8.15,
Not
OK
Before troubleshooting any
electrical circuit, ALWAYS
begin by checking the
following:
1. Fuses.
2. All connections relating to
circuit are clean and tight.
Solenoids are energized.
Identify short in either the cab
or engine harness on
wires [8] or [9] to battery
voltage. Repair/replace
shorted harness.
If OK
Verify 0 volts at steer select
switch, Pins 1 and 3.
If OK
Replace steer select switch.
†
SN 13198 through 16782 w/o Lighting Package. See pages 9.38, 9.39, 9.62, 9.63, 9.84 or 9.85.
§
SN 13198 through 16782 w/Lighting Package and SN 16783 through 18990. See pages 9.40, 9.41, 9.64, 9.65, 9.86 or 9.87.