SkyTrak 8042 Service Manual - Manual (Page 221)

Boom
3.160 Model 8042, 10042, 10054 Legacy Rev. 03/04
12. Loosen the wear pad mounting bolts (6) holding the
hose guide (7) and wear pads (8) to the side of the
inner boom. Remove the wear pad mounting bolts
(one at a time) with washers.
13. Apply Loctite
®
242 threadlocker to the threads of the
the hose guide and wear pad mounting bolt (6).
Reinsert the bolts with washers but DO NOT fully
tighten. Swing the back of the hose guide down to
line up the rear notches with the holes in each side
of the inner boom.
Note: ALWAYS replace elastic locknuts with new elastic
locknuts to help ensure proper fastening.
14. Insert a capscrew (9), saved, through the hole in the
inner boom. Secure the hose guide in place with a
flat washer (10), saved, and a new elastic
locknut (11). Tighten securely.
15. Tighten the wear pad and hose guide capscrews.
Torque all wear pad mounting capscrews to 31 ±3 lb-ft
(42 ±4 Nm).
16. Run the hose carrier out and in by hand to check for
interference.
MH2470
2
1
2
3
4
5
MH2480
6
7
8
9
10
11