SkyTrak 8042 Service Manual - Manual (Page 61)

General Information and Specifications
2.36 Model 8042, 10042, 10054 Legacy Rev. 10/03
2.12.7 After Tire and Wheel Service
1. Check the air pressure in the tires. Maintain proper
air pressure at all times. Refer to proper tire size as
follows:
Standard Tires
• 8042 (13.00-24, 12 ply) 70 psi (483 kPa)
• 10042/10054 (17.5-25, 12 ply) 60 psi (414 kPa)
Optional Tires - 8042
• 15.5 - 25, 12 ply 70 psi (483 kPa)
• 15.5 - 25, 12 ply, (Rock) 70 psi (483 kPa)
• 15.5R25 One Star (Radial) 75 psi (517 kPa)
Optional Tires - 10042/10054
• 17.5R25 One Star (Radial) 73 psi (503 kPa)
2. Check the wheel nut torque. Torque the wheel nuts
to 450 lb-ft (610 Nm).
2.12.8 After Engine Service
Consult a qualified service agent (manufacturer’s
representative and/or service manual) for proper procedures
before engine startup.
2.12.9 After Boom Service
1. Check wear pads.
2. Check chain tension, and adjust as required.
3. Apply grease to all lubrication points (grease fittings).
Note: Refer to the appropriate Owners/Operators
manual for the grease fitting locations.
4. Check for proper operation by operating all boom
functions through their full range of motion several
times.
2.12.10 After Axle Service
1. Check the fluid levels in the axle and wheel ends.
2. Check the torque on the driveshaft flange yoke
retaining strap bolts. Torque these bolts to 60 lb-ft
(81 Nm).
3. Check the torque on the wheel nuts. Torque to 430-
470 lb-ft (583-637 Nm).
4. Check and adjust the toe-in if required.
5. Apply grease to all lubrication points (grease fittings).
Note: Refer to the appropriate Owner/Operators manual
for the grease fitting locations.
6. Refer to the axle manufacturer’s maintenance
manual for further information.