SkyTrak 8042 Service Manual - Manual (Page 401)

Engine: Cummins QSB4.5T
7B.34 Model 8042, 10042, 10054 Legacy Rev. 10/03
6. Remove the radiator overflow tube (1), overflow tank
(2), hose support (3), flat washer (4) and elastic
locknuts (5).
Note: Record how the alternator and starter wires are
installed to ensure correct installation later.
7. Label and disconnect the alternator wires:
• AG1 and AG2 from G terminal (6)
• AB1 and AB2 from B terminal (7)
• 38 and 6 from D terminal (8)
8. At the positive starter stud (9), label and disconnect
the positive (+) battery cable (10) and starter positive
buss bar (11). Leave the wires (12) connected to the
starter positive buss bar.
9. At the negative starter stud (13), label and
disconnect the negative (-) battery cable (14).
10. Remove the engine ground buss bar (15) from the
engine block. Leave the wires (16) connected to the
engine ground buss bar.
11. For jump start protection, a protective plastic
cover (17) is installed around the starter solenoid
terminal and mounting screw. A removable, tethered
cap (18) allows access to the terminal mounting
screw.
MH4730
1
2
3 4
5
MH5670
6 7 8
MH5660
13
14
9
10
11
12
15
16
MU1351
18
19
20
17