SkyTrak 8042 Service Manual - Manual (Page 612)

9.21 Model 8042, 10042, 10054 Legacy Rev. 10/03
Electrical System
ECM Fuses
1. Locate the three fuse holders. Remove the clear
plastic protective cover (10) from the holder (11).
2. Remove the failed fuse from the holder and replace
with a new fuse.
3. Reassemble the plastic cover onto the fuse holder
and securely snap the cover in place. Replace any
tie wraps that were removed, securing the fuse
holders to the wire harness.
c. Engine Compartment Relay Replacement
(SN 8042, 18991 - 19987, 10042 19031 - 19987,
10054, 19080 - 19987 And
8042/10042/10054, 0160002332 & After)
To remove the relays (12) from inside the engine
compartment, remove the mounting screws and
washers (13). When re-installing the relays torque the
mounting hardware to 5 - 9 lb-ft (7 - 12,5 Nm).
d. After Fuse or Relay Service
If the vehicle has one battery, connect the negative (-)
battery cable to the negative (-) battery terminal (1).
If the vehicle has dual batteries, connect both negative
battery cables to both negative (-) battery terminals (2).
MH4930
10
11
MH4910
13
12