SkyTrak 8042 Service Manual - Manual (Page 399)

Engine: Cummins QSB4.5T
7B.32 Model 8042, 10042, 10054 Legacy Rev. 10/03
5. Disconnect and remove the clamp (1) supporting the
tail pipe (2), from the tail pipe support bracket (3).
6. Disconnect and remove the clamp (4) attaching the
muffler (5) to the muffler mounting bracket (6) and
exhaust pipe (7), and remove the muffler from the
muffler mounting bracket.
7. Disconnect and remove the V-band clamp (8) from
the exhaust pipe (7) and remove the exhaust pipe.
8. Disconnect and remove the muffler mounting bracket
(6) and tail pipe support bracket (3) from the rear
engine mount (9).
7B.9.2 Exhaust System Installation
Note: Keep all clamps loosened until entire exhaust
system is in place.
1. Install the muffler mounting bracket (6) and tail pipe
support bracket (3) to the rear engine mount (9).
2. Install the V-band clamp (8) to the exhaust pipe (7)
3. Secure the tail pipe (2) with the clamp (1) to the tail
pipe support bracket (3).
4. Attach the muffler (5) to the muffler mounting bracket
(6) and exhaust pipe (7) with the clamp (4).
5. Tighten all clamps.
6. Connect the negative (-) battery cables (10) to the
batteries.
7. Start engine and check for exhaust leaks at all
exhaust connections. Adjust or repair as needed.
7B.10 AIR CLEANER ASSEMBLY
If a replacement engine is being installed into the vehicle,
the air cleaner assembly must be transferred to the new
engine.
The air cleaner assembly should be transferred to the
replacement engine after the used engine is removed
from the vehicle.
IMPORTANT: Before transferring the air cleaner
assembly to the new engine, remove the elements and
clean the inside and outside of the air cleaner canister.
Replace the outer primary and inner safety elements.
Refer to the appropriate Owners/Operators Manual for
your vehicle for the correct element change procedure.
7B.10.1 Air Cleaner Assembly Removal
1. Remove the T-bolt band clamp (11) securing the air
scoop (12) to the air cleaner assembly (13).
MH4600
Rear of vehicle
1
2
3
4
5
6
7
8
9
CAUTION:
NEVER run the engine with
only the inner safety element installed.
MH4440
12
10