SkyTrak 8042 Service Manual - Manual (Page 269)

Cab and Covers
4.30 Model 8042, 10042, 10054 Legacy Rev. 10/03
Follow steps 16 thru 18 for: 8042 S/N 13198 thru 18990,
10042 S/N 13198 thru 19030 or 10054 S/N 13198 thru
19079.
16. Remove one elastic locknut (1). Disconnect the
throttle cable rod end (2) at the throttle lever
extension bracket (3).
17. Remove two slotted pan-head screws (4) two
lockwashers, two hex nuts and clamp (5) from the
throttle cable bracket (6).
18. Cut the wire ties securing the throttle cable to the
hydraulic hoses on the right side of the frame, and
route the throttle cable (7) out of the engine
compartment and through the opening in the bottom
of the frame. Allow the cable to hang beneath the cab.
19. Attach a clevis (8 and 9) to each of the cab lifting
brackets. Route a sling (10) with a suitable lifting
capacity to carry the weight of the cab through the
clevis’ to a hoist or overhead crane. Make sure the
sling is centered between the clevis’ to ensure even
lifting.
20. Remove the two upper cab-to-frame capscrews (11)
and two flat washers (12).
21. Remove the two lower cab-to-frame capscrews (13)
and two flat washers (14).
22. Remove the mirrors and all other cab components,
refer to Section 4.4.5, “Heater/Defroster System
Components,” Section 4.4.6, “Door and Latches,”
and Section 4.4.7, “Windows,” as needed, if not
previously removed.
23. Carefully begin to lift the cab. Stop and check that all
wiring, hydraulic hoses and fasteners are
disconnected or removed. If the throttle cable (for
8042 S/N 13198 thru 18990, 10042 S/N 13198 thru
19030 or 10054 S/N 13198 thru 19079) is still
attached to the cab, reposition or remove the throttle
cable as necessary.
24. When all wiring, hydraulic hoses and fasteners are
disconnected or removed, carefully and slowly lift the
cab and remove it from the frame. Readjust the
position of the sling as needed to help balance the
cab during removal.
25. When the cab is completely clear of the vehicle,
carefully lower it to the ground. Block up or support
the cab so that it does not move or fall. Assure that
no personnel enter the cab while it is being removed
from the vehicle.
26. Inspect the condition of the fittings, clamps, hydraulic
hoses, etc. Replace parts as indicated by their
condition.
27. Inspect and replace other vehicle parts that are
exposed with the cab removed. Repair or replace as
required.
MA8610
1
2
3
4
5
6
7
4
~
MH3330
8
9 10
11
12
13
14
11
13
12
14