SkyTrak 8042 Service Manual - Manual (Page 706)

9.115 Model 8042, 10042, 10054 Legacy Rev. 10/03
Electrical System
Check 40 amp main fuse and
7.5 amp transmission fuse.
Check that transmission gear
select lever is in the
NEUTRAL (N) position.
Engine will not crank or
starter solenoid does
not engage.
Check that parking brake
switch is ENGAGED.
Check battery for proper
charge and that connections
are clean and tight.
With ignition switch in START
position, check starter
solenoid terminal, wire
[106] (BLU/ORG) connection
for battery voltage.
Replace starter.
Check for battery voltage at
starter positive (+) battery
post (RED cable). Check
negative (-) cables for proper
ground and that they are
clean and tight.
Continued on Page 9.117
Clean, tighten and recheck.
Before troubleshooting any
electrical circuit, ALWAYS
begin by checking the
following:
1. All connections relating to
circuit are clean and tight.
2. On 10042 or 10054, if the
vehicle is starting hard,
make sure that both
outrigger switches are in
the neutral (center)
position. If OK
Not
OK
If OK
If OK
If OK
If OK
If OK
† SN 13198 through 16782 w/o Lighting Package. See pages 9.38, 9.39, 9.62, 9.63, 9.84 or 9.85.
§ SN 13198 through 16782 w/Lighting Package and SN 16783 through 18990. See pages 9.40, 9.41, 9.64, 9.65, 9.86 or 9.87.
These wires are not part of a wire harness. Refer to the appropriate Parts Manual for part number information.