Triton Isis - Manual (Page 98)

June 2004 Isis® Sonar User's Manual, Volume1 84
See the procedure entitled ‘To print a single screen from Isis 2.11
or later’
for the related settings.
5.5.3 Using an EPC 9502 Plotter with Isis
Triton Elics has tested an EPC 9502 plotter (serial number 109). It
works with the current version of Isis.
1. Follow the general procedure described in §5.2.
2. From
the File→Print→Plotter Setup series of menus in the Isis
software program, choose EPC 980X as your plotter.
Note:
Unlike the EPC 1086 plotter model, the EPC 9502 does not
require that you make special settings at the plotter.
Consequently, you can print single-screen images or
continuous waterfall images from Isis without any changes.
5.5.4 Waverley 195 Plotter with Isis
As noted above, the Waverley 195 plotter is the same as the Dowty
195, Ultra 195 and Ultra 200 plotters. Before you can use any of
these plotters with Isis, check to see that your plotter is properly
connected and configured for Isis. You also may need to run some
simple tests if you don’t get any printed output. Use the following
procedures as a guide.
To connect the plotter to your Isis
1. Take a standard printer cable (not a straight-through DB25
cable) and connect one end to your LPT1 port.
2. Connect the other end to the parallel port interface labeled
“Centronics”.
To configure the plotter for Centronics mode of operation
1. Choose Standby mode.
2. Press [Shift] [ONLINE] until SBY appears.
3. Press SETUP twice.
4. Press ENTER until Centronics appears.
Chapter 5: Printing in Isis