Triton Isis - Manual (Page 305)

June 2004 Isis® Sonar User's Manual, Volume 1 291
SCSI device is
not recognized If hard drive is
not recognized,
system will not
boot Possibly “Invalid
drive
specification” SCSI cable connectors not
seated; press firmly on all
SCSI connectors.
SCSI bus improperly
terminated; refer to
Appendix C for correct
SCSI bus setup.
Blown SCSI adapter board
fuse, possibly due to over-
termination; pull fuse, test
and replace if necessary
(see Drawing 601-93-42),
double-check bus
termination.
CPU I/O chip failure;
replace CPU board.
CMOS Setup
Lost “...Press Delete
to run setup”
CMOS battery backup has
low voltage or has been
jarred loose; reseat or
replace it; then run setup
routine by pressing
when prompt appears
during start-up. Refer to
Appendix A for proper
CMOS settings.
System has
Target option but
will not log a
contact or contact
information is
corrupted Possibly “Out of
memory” File CONTACTS.BIN is too
large or corrupted; delete
the file and try again.
Default Isis
parameters
appear to be
corrupted File ISIS.CFG is corrupted;
quit Isis, delete the file and
try again.
Chapter 12: Maintenance and Troubleshooting