Triton Isis User Manual
Page 151
June 2004 Isis® Sonar User's Manual, Volume1
137
In this example, all values have been entered manually. Note that the Cable Out
and Depth checkboxes are checked, allowing manual entry of these values.
Height of towpoint and Offset values have also been entered. Clicking Apply
causes Isis to use these values to make the layback calculation and to display
the value in the Current value panel.
In
Record
Mode these values are written to the .XTF file.
In
Playback
Mode the Current value is the value applied to the towfish position
during a mosaicking session, or to a Target or TargetPro position. Note that
entering a value here would
not
modify the original value in the .XTF file.
To Calculate Layback from Cable Out and Other Parameters by entering
values automatically
If the information for Depth and Cable Out were being received over a serial port
using the template tokens 0 (towfish depth) and o (cable out), then the dialog box
would appear like shown in Figure 8-12.
Chapter 8: Using the View Menu