Grass Valley iControl V.6.02 - Manual (Page 90)

Getting Started with iControl
From Application Server to SMTP Server
80
From Application Server to SMTP Server
Cisco Switch Configuration
This section provides instructions for configuring a Cisco Catalyst 2900 series switch for use on
an iControl network
Using Privileged EXEC Mode
The commands specified in this document require that the reader use the system in the
privileged EXEC mode.
Entering Privileged EXEC Mode
To enter privileged EXEC mode
1. At the Switch prompt, type: enable <CR>
2. Type the password (either no password or admin )
If successful, the prompt changes to Switch# .
Exiting Privileged EXEC Mode
To exit privileged EXEC mode
1. At the Switch prompt, type: disable <CR>
2. Type the password (either no password or admin )
Service Port Transport Notes
SMTP 25 TCP Simple Mail Transfer Protocol, for email alerts
FEATURE DEFAULT SETTING
IP address and subnet mask No IP address or subnet mask defined
Default gateway No default gateway defined
Enable secret password No password defines
Host name Factory assigned default host name id ‘Switch’
Telnet password No password defined
Cluster command switch functionality Disabled
Cluster name No cluster name defined
Note: Default passwords are either undefined or admin .