Grass Valley iControl V.6.02 - Manual (Page 416)

iControl and SNMP
Editing Procedures
406
The alarms are published.
Editing Procedures
Editing an Alarm
To edit an alarm
1. In SNMP Driver Creator, in the Alarms list, select the alarm you would like to edit, and then
click Edit.
The Edit Alarm window appears.
2. Modify the alarm’s parameters as required, and then click OK.
REQUIREMENTS
Make sure you meet the following conditions before beginning this procedure:
• You have opened SNMP Driver Creator (see page 578 ).
• You have loaded a MIB module into SNMP Driver Creator (see page 390 ).
• You are displaying the Alarms tab in SNMP Driver Creator.
• You have configured your driver settings (see page 393 ).
Note: From the Edit an Alarm window, you may also create new alarm maps, trap
maps, and pollers.