Grass Valley iControl V.6.02 - Manual (Page 506)

Backup and Redundancy
Replacing an Application Server in a Redundancy Group
496
2. Click Apply.
3. If required, add this Application Server to the Redundancy Group (see page 483 ).
Replacing an Application Server in a Redundancy Group
When the current IP is unknown and the operation state is Offline, operators may choose to
replace the Application Server. The Replace function switches the online, Main Application
Server with another Application Server outside the Redundancy Group.
Note: This procedure is applicable only if the Take over the main IP address after
failover check box is selected (on the iControl—Redundancy configuration page). If
this check box was cleared when an Auto-failover or Manual Takeover occurred, you
will need to perform the procedure see
"Restoring Configuration Data to an
Application Server" , on page 476.