Grass Valley iControl V.6.02 - Manual (Page 505)

iControl
User Guide
495
12. If your Redundancy Group has more Application Servers than just A1 and A2, perform the
following steps:
a) In your browser’s address bar, type the IP address of one of the Application Servers
(neither A1 nor A2) still remaining in the Redundancy Group.
b) Navigate to the iControl—Redundancy configuration page (see page 559 ).
c) In the Main area, type the IP address of A2.
d) Click Add this Main (next to the IP address you just typed).
The iControl—Redundancy configuration page refreshes, displaying A2 has been added
to the Main area.
e) In the Backup area, type the IP address of A1.
f ) Click Add this Backup (next to the IP address you just typed).
The iControl—Redundancy configuration page refreshes, displaying A1 has been added
to the Backup area.
Configuring and Managing Autofailovers of Application Servers
To change the IP address of an Application Server
1. On the iControl—Network interfaces page, under Eth0, type a new IP address in the
IP Address box.
REQUIREMENTS
Make sure you meet the following conditions before beginning this procedure:
• You have opened the iControl—Network interfaces page of the Application Server whose
IP address you would like to change (see page 563 ).
• You have removed this Application Server from the Redundancy Group (see page 487 ).