Grass Valley iControl V.6.02 - Manual (Page 436)

iControl and SNMP
AppServer Health Monitoring Plug-in
426
The Net-SNMP agent is running by default. There is no configuration necessary on the iControl
side. You will need to compile the Net-SNMP MIBs in the third party SNMP manager, specifying
the Application Server’s IP address and port 1161.
AppServer Health Monitoring Plug-in
The AppServer Health Monitoring plug-in is a custom SNMP driver created by Grass Valley that
takes advantage of the Net-SNMP agent to monitor the health of an iControl Application
Server and its services. This plug-in polls the Net-SNMP agent for health monitoring data, and
reports the results within the GSM’s Alarm Browser.
The following screens show typical alarms available via the GSM AppServer Health Monitoring
plug-in.
UCD-SNMP-MIB
ssCPUidle laLoad .2 memTotalReal dskTotal
ssCPUuser laLoad .3 memAvailableReal dskAvail
ssCPUsystem memTotalSwap memBuffer dskUsed
laLoad .1 memAvailableSwap memCached dskPercent
HOST-RESOURCE-MIB
hrSystemNumUsers hrSystemProcesses
IF-MIB
ifDescr ifSpeed ifInDiscards ifOutDiscards
ifInErrors ifOutErrors ifInOctets . ifOutOctets
SNMPv2-MIB
sysUpTime sysContact sysName