Grass Valley iControl V.6.02 - Manual (Page 421)

iControl
User Guide
411
Creating a GSM SNMP Agent for all Alarms
To create a GSM SNMP agent for all alarms
1. In the GSM Alarm Browser, select a GSM from the list on the left pane.
2. On the right pane, click on the Admin tab, and then click on the Actions sub-tab.
3. Click Add global.
The New Action window appears.
4. Select SNMP agent in the list of new actions, and then click New.
The SNMP Agent Configuration window appears.
5. Enter values for the following parameters depending upon your needs:
WARNING: Depending on the scale of your GSM-visible alarm footprint, performing this
procedure may have a detrimental impact upon iControl, a destination
SNMP manager, or general network performance. Care should be taken when
configuring GSM SNMP agents for all alarms.
REQUIREMENTS
Make sure you meet the following conditions before beginning this procedure:
• You have separately ordered and installed the SNMP Agent plug-in option. To order this,
contact Grass Valley Technical Support (see "Contact Us" , on page 599).
• You have opened the GSM Alarm Browser (see "Opening the GSM Alarm Browser" ,
on page 577).
Note: The graphics depicted above and below show the GSM Alarm Browser if it is
opened from the View menu of iC Navigator. If, however, you have opened the
GSM Alarm Browser by double-clicking a GSM in iC Navigator’s Logical View, you will
not see a left pane with a list of GSMs.