Grass Valley iControl V.6.02 - Manual (Page 406)

iControl and SNMP
Creating an Alarm Map
396
4. Click OK.
A new alarm is created and listed in the Alarms table.
Creating an Alarm Map
There are several ways in which you can create an alarm map. The differences lie in the way in
which you navigate to the Create Alarm Map window.
To create an alarm map
1. Open the Create Alarm Map window by doing only ONE of the following:
• In SNMP Driver Creator, on the Alarms tab, click New alarm map.
Alarm subpath The path in the Alarm Browser tree where the alarm is created
Alarm map The associated alarm map for this alarm
Trap map The associated trap map for this alarm
Poller profile The associated poller for this alarm
See also
For more information about editing an existing alarm any time after it has been created,
see
page 406 .
REQUIREMENTS
Make sure you meet the following conditions before beginning this procedure:
• You have opened SNMP Driver Creator (see page 578 ).
• you have loaded a MIB module into SNMP Driver Creator (see page 390 ).
• [RECOMMENDED]: You are performing this procedure as a task within the context of an
approved workflow (see "[Workflow]: Creating an SNMP Driver" , on page 379).
(Continued)
Parameter Description