beautypg.com

EXFO CableSHARK P3 VF/DSL Cable Qualifier User Manual

Page 30

background image

VF / DSL Cable Qualifier

18

3.

Serial Communication Port (Male)

The 9-pin connector provides serial communication with a computer. The CableSHARK can

download its results to a terminal program or be remote controlled via the optional Microsoft

Windows® based Visi-SHARK program. This port is also used to upgrade the software version

resident within the CableSHARK.


4.

Ethernet 10BaseT Port

The Ethernet connector provides high-speed communication with a computer. The CableSHARK
can download its results to a terminal program or be remote controlled via the optional Microsoft
Windows® based Visi-SHARK program. This port is also used to upgrade the software version
resident within the CableSHARK.. Users will have to define their IP address, Gateway address
and subnet mask under System Setup.

5. RJ-45

connector

RJ-45 connector for connection to the line. Supports 2 wire TX and RX functionality.


6. RJ-11

connector

RJ-11 connector for connection to the line. Supports 2 wire TX and RX functionality.


7.

2 Wire TX & RX 3 Pin Connector

3 Pin connector for connection to the line and acting as a transmitter and receiver. This connector

can be used in conjunction with the Rx (AUX.) connector and acts as the transmitter for 4 Wire

implementations.


8.

Rx (AUX.) 3 Pin Connector

3 Pin connector for connection to the line and acting as a receiver (RX) only. This allows access

to the 4 wire features of the CableSHARK . Features Tip, Ring, and Ground connections. The Rx

(AUX) connector is also used for the “Good Pair” connection in RFL (Yellow and Green telco clip

cable).

4.1.3 The Serial Interface Connection

The serial interface is used to connect the CableSHARK to a PC terminal. The connector for this is a male 9
pin D-type on the rear panel. When connecting to your equipment, a 9 pin “D” to 25 pin “D” type cable or
conversion adapter may be required. The serial interface is compatible with the EIA RS-232 and ITU V.24
specifications. The pin assignments for this are as follows: