Allied Telesis AT-S62 - Manual (Page 86)

Chapter 6: MAC Address Table
86 Section I: Basic Operations
The default selection is the View All option for unicast MAC addresses.
To avoid displaying the wrong MAC addresses, check to be sure that
you have selected the desired unicast or multicast address option
before clicking a View button.
View All
This selection displays all dynamic addresses learned on the ports of
the switch and all static addresses that have been assigned to the
ports.
View Static
This selection displays just the static addresses assigned to the ports
on the switch.
View Dynamic
This selection displays just the dynamic addresses learned on the
ports on the switch.
View MAC Addresses on Port
Displays the dynamic and static MAC addresses of a particular port.
You can specify more than one port at a time.
View MAC Addresses for VLAN
Displays the static and dynamic addresses learned on the tagged and
untagged ports of a specific VLAN. You specify the VLAN by entering
the VLAN ID number. You can specify only one VLAN at a time.
View MAC Address
Displays the port number on which a MAC address was assigned or
learned.
In some situations, you might want to know which port a particular
MAC address was learned on. You could display the MAC address
table and scroll through the list looking for the MAC address. But if the
switch is part of a large network, finding the address could prove
difficult.
This option offers an easier way. You can specify the MAC address
and let the management software automatically locate the port on the
switch where the device is connected.
4. After you select an option, click View. The columns in the MAC
address page are defined below.
Vlan ID - The ID number of the VLAN where the port is an untagged
member.
MAC Address - The static or dynamic unicast MAC address.
Port(s) - The port on which the address was learned or assigned. The
MAC address with port “CPU” is the address of the switch.
Type - The type of the address: static or dynamic.