Allied Telesis AT-S62 - Manual (Page 314)

Chapter 22: GARP VLAN Registration Protocol
314 Section V: Virtual LANs
Enabling or Disabling GVRP on a Port
This procedure enables and disables GVRP on a switch port. The default
setting for GVRP on a port is enabled. Only those ports where GVRP is
enabled transmit PDUs.
Note
Allied Telesyn recommends disabling GVRP on unused ports and
those ports that are connected to GVRP-inactive devices. This will
protect against unauthorized access to restricted areas of your
network.
1. From the Home Page, select Configuration.
2. Select the Layer 2 menu selection.
3. Select the GVRP tab.
The GVRP tab is shown in Figure 103 on page 312.
4. Click the port you want to configure in the graphic image of the switch.
A selected port turns white. To deselect a port, click it again. You can
configure more than one port at a time.
5. Click Modify.
The GVRP Port Configuration page is shown in Figure 104.
Figure 104. GVRP Port Configuration Page
6. Change the port mode if desired.
A setting of Normal means the port processes and propagates GVRP
information. This is the default setting. A setting of None prevents the
port from processing GVRP information and from transmitting PDUs.
7. Click Apply.
The change to the GVRP port mode is activated on the port.