Allied Telesis AT-S62 - Manual (Page 324)

Chapter 24: MAC Address-based Port Security
324 Section VI: Port Security
Configuring MAC Address-based Port Security
MAC address-based port security allows you to control access to a port on
the switch using the MAC addresses of the end nodes. To configure this
security feature, perform the following procedure:
1. From the Home page, select Configuration.
2. Select the Network Security menu selection.
3. Select the Port Security tab.
The Port Security tab is shown in Figure 105.
Figure 105. Port Security Tab
4. Click the port to be configured. A selected port turns white. To deselect
a port, click it again. You can configure more than one port at a time.
5. Click Modify.