Allied Telesis AT-S62 - Manual (Page 313)

AT-S62 Management Software Web Browser Interface User’s Guide
Section V: Virtual LANs 313
Join Time
Sets the duration of the Join Period timer. The range is from 10 to 60
centiseconds and the default is 20.
If you change this timer, it must in relation to the GVRP Leave Timer
according to the following equation:
Join Timer <= 2 x (GVRP Leave Timer)
Enable GIP
Enables the operation of GIP. If enabled, attribute registrations and de-
registrations processed on a port are propagated to other ports in the
GIP-connected ring. GIP must be enabled in order to use GVRP.
Note
Do not disable GIP if you intend to use GVRP. GIP is required to
propagate VLAN information among the ports of the switch.
Leave All Time
Sets the duration of the LeaveAll Period timer. The range is from 500
to 3000 centiseconds and the default is 1000.
Caution
The settings for the three GVRP timers must be the same on all GVRP-
active devices in your network.
5. Click Apply.
The new GVRP settings are activated on the switch.
6. To permanently save the changes, select the Save Config menu
selection.