Allied Telesis AT-S62 - Manual (Page 330)

Chapter 25: 802.1x Port-based Network Access Control
330 Section VI: Port Security
Enabling and Disabling Port-based Access Control
This procedure explains how to enable and disable port-based access
control on the switch. If you have not assigned port roles and configured
the parameter settings, you should skip this procedure and go first to
“Setting Port Roles” on page 333. This procedure also explains how to
configure RADIUS accounting.
To enable or disable port-based access control or configure RADIUS
accounting, perform the following procedure:
1. From the Home Page, select Configuration.
2. Select the Network Security menu selection.
3. Select the 802.1x Port Access tab.
The 802.1x Port Access tab is shown in Figure 108.
Figure 108. 802.1x Port Access Tab (Configuration)