Allied Telesis AT-S62 - Manual (Page 171)

AT-S62 Management Software Web Browser Interface User’s Guide
Section II: Advanced Operations 171
All - All packets are remarked.
DSCP Value
Specifies a replacement value to write into the DSCP (TOS) field of the
packets. The range is 0 to 63.
A new DSCP value can be set at all three levels: flow group, traffic
class, and policy. A DSCP value specified in a flow group overrides a
DSCP value specified at the traffic class or policy level. A DSCP value
specified at the policy level is used only if no value has been specified
at the flow group and traffic class levels.
Traffic Class List
Specifies the traffic class to be assigned to the policy. The traffic class
must already exist. A policy can have more than one traffic class. To
select more than one traffic class, hold down the Ctrl key when making
your selections.
Ingress Port List
Specifies the ingress port to which the policy is to be assigned. A policy
can be assigned to more than one port. To select more than one port,
hold down the Ctrl key when you make your selections. A port can be
an ingress port of only one policy at a time.
Egress Port
Specifies the egress port to which the policy is to be assigned. You can
enter only one egress port. The egress port must be within the same
port block as the ingress ports. On switches with 24 ports (plus
uplinks), ports 1-26 form a port block. On switches with 48 ports (plus
uplinks), ports 1-24 and 49 form one port block and ports 25-48 and 50
form a second port block.
A port can be an egress port of only one policy at a time. If a port is
already an egress port of a policy, you must remove the port from its
current policy assignment before adding it to another policy.
Redirect Port
Specifies a port to where the traffic is to be redirected. Traffic that
matches the defined traffic flow is redirected to the specified port. You
can specify only one port.
6. Click Apply.
7. To permanently save your changes, select the Save Config menu
selection.