Allied Telesis AT-S62 - Manual (Page 239)

AT-S62 Management Software Web Browser Interface User’s Guide
Section III: SNMPv3 239
Configuring the SNMPv3 Target Address Table
You can create, delete, and modify an SNMPv3 Target Address Table
entry. See the following procedures:
ˆ “Creating a Target Address Table Entry” on page 239
ˆ “Deleting a Target Address Table Entry” on page 242
ˆ “Modifying Target Address Table Entry” on page 243
For reference information about the SNMPv3 Target Address Table, see
“Configuring the SNMPv3 Target Address Table” on page 239.
Creating a Target
Address Table
Entry
To create an entry in the SNMPv3 Target Address Table, perform the
following procedure.
1. From the Home Page, select Configuration.
2. Select the Mgmt Protocols menu selection.
3. Select the SNMP Tab.
The SNMP Tab is shown in Figure 58 on page 206.
4. In the SNMPv3 section of the page, click the circle next to Configure
Target Address Table. Then click Configure at the bottom of the page.