Allied Telesis AT-S62 - Manual (Page 210)

Chapter 19: SNMPv3
210 Section III: SNMPv3
8. In the Authentication Password field, enter an authentication password
of up to 32 alphanumeric characters.
9. In the Confirm Authentication Password field, re-enter the
authentication password.
Note
If you have the AT-S60 software version 2.1.0 that does not contain
the encryption features, then the Privacy Protocol field is read-only
field and it is set to None.
Note
You can only configure the Privacy Protocol if you have configured
the Authentication Protocol with the MD5 or SHA values.
10. In the Privacy Protocol field, enter one of the following options:
DES
Select this value to make the DES privacy (or encryption) protocol the
privacy protocol for this User Table entry. With this selection,
messages transmitted between the host and the switch are encrypted
with the DES protocol.
None
Select this value if you do not want a privacy protocol for this User
Table entry. With this selection, messages transmitted between the
host and the switch are not encrypted.
11. In the Privacy Password field, enter a privacy password of up to 32
alphanumeric characters.
12. In the Confirm Privacy Password field, re-enter the privacy password.
13. In the Storage Type field, enter one of the following storage options for
this table entry:
Volatile
Select this storage type if you do not want the ability to save an entry in
the User Table to the configuration file. After making changes to an
User Table entry with a Volatile storage type, the Save Config menu
selection does not appear.
NonVolatile
Select this storage type if you want the ability to save an entry in the
User Table to the configuration file. After making changes to an User
Table entry with a NonVolatile storage type, the Save Config menu
selection appears.