Allied Telesis AT-S62 - Manual (Page 229)

AT-S62 Management Software Web Browser Interface User’s Guide
Section III: SNMPv3 229
Configuring the SNMPv3 SecurityToGroup Table
You can create, delete, and modify an SNMPv3 SecurityToGroup Table
entry. See the following procedures:
ˆ “Creating a SecurityToGroup Table Entry” on page 229
ˆ “Deleting a SecurityToGroup Table Entry” on page 231
ˆ “Modifying a SecurityToGroup Table Entry” on page 232
For reference information about the SNMPv3“Configuring the SNMPv3
SecurityToGroup Table” on page 229.
Creating a
SecurityToGroup
Table Entry
To create an entry in the SNMPv3 SecurityToGroup Table, perform the
following procedure.
1. From the Home Page, select Configuration.
2. Select the Mgmt Protocols menu selection.
3. Select the SNMP Tab.
The SNMP Tab is shown in Figure 58 on page 206.
4. In the SNMPv3 section of the page, click the circle next to Configure
SecurityToGroup Table. Then click Configure at the bottom of the
page.
The SNMPv3 SecurityToGroup Table Page is shown in Figure 68.
Figure 68. SNMPv3 SecurityToGroup Table Page