Allied Telesis AT-S62 - Manual (Page 283)

AT-S62 Management Software Web Browser Interface User’s Guide
Section IV: Spanning Tree Protocols 283
Configuring MSTP
This section is divided into the following procedures:
ˆ “Configuring MSTP and CIST Parameters” on page 283
ˆ “Associating VLANs to MSTIs” on page 286
ˆ “Configuring MSTP Port Parameters” on page 289
This procedure assumes that you have already designated MSTP as the
active spanning tree on the switch. For instructions, refer to “Enabling or
Disabling Spanning Tree” on page 272.
Configuring
MSTP and CIST
Parameters
To configure MSTP parameters, perform the following procedure:
1. From the Home page, select Configuration.
2. From the Configuration page, select Layer 2.
3. From the Layer 2 page, select the Spanning Tree tab.
The Spanning Tree Web Page appears as shown in Figure 91 on page
272.
4. Click Configure.