Allied Telesis AT-S62 - Manual (Page 226)

Chapter 19: SNMPv3
226 Section III: SNMPv3
Deleting an
Access Table
Entry
To delete an entry in the SNMPv3 Access Table, perform the following
procedure.
1. From the Home Page, select Configuration.
2. Select the Mgmt Protocols menu selection.
3. Select the SNMP Tab.
The SNMP Tab is shown in Figure 58 on page 206.
4. In the SNMPv3 section of the page, click the circle next to Configure
Access Table. Then click Configure at the bottom of the page.
The SNMPv3 Access Table Page is shown in Figure 65 on page 222.
5. Display the Access Table entry that you want to delete.
Click Next or Previous to display an entry.
6. Click Remove.
A warning message is displayed. Click OK to remove the Access Table
entry.
7. To save your changes, select the Save Config menu selection.