Allied Telesis AT-S62 - Manual (Page 209)

AT-S62 Management Software Web Browser Interface User’s Guide
Section III: SNMPv3 209
5. Click the Add button to add a new SNMPv3 User Table entry.
The Add New SNMPv3 User Page is shown in Figure 60
Figure 60. Add New SNMPv3 User Page
6. In the User Name field, enter a name, or logon id, that consists of up to
32 alphanumeric characters
7. In the Authentication Protocol field, enter an authentication protocol.
This is an optional parameter.
Select one of the following:
MD5
This value represents the MD5 authentication protocol. With this
selection, users are authenticated with the MD5 authentication
protocol after a message is received. With this selection, you can
configure a Privacy Protocol.
SHA
This value represents the SHA authentication protocol. With this
selection, users are authenticated with the SHA authentication protocol
after a message is received. With this selection, you can configure a
Privacy Protocol.
None
This value represents no authentication protocol. When messages are
received, users are not authenticated. With the None selection, you
cannot configure a Privacy Protocol.