Allied Telesis AT-S62 - Manual (Page 232)

Chapter 19: SNMPv3
232 Section III: SNMPv3
A warning message is displayed. Click OK to remove the SNMPv3
SecurityToGroup Table entry.
6. To save your changes, select the Save Config menu selection.
Modifying a
SecurityToGroup
Table Entry
To modify an entry SNMPv3 SecurityToGroup Table, perform the
following procedure.
1. From the Home Page, select Configuration.
2. Select the Mgmt Protocols menu selection.
3. Select the SNMP Tab.
The SNMP Tab is shown in Figure 58 on page 206.
4. In the SNMPv3 section of the page, click the circle next to Configure
SecurityToGroup Table. Then click Configure at the bottom of the
page.
The SNMPv3 SecurityToGroup Table Page is shown in Figure 68 on
page 229.
5. Click the circle next to the SecurityToGroup Table entry that you want
to change. Then click Modify.
The Modify SNMPv3 SecurityToGroup Page is shown in Figure 70.
Figure 70. Modify SNMPv3 SecurityToGroup Page
6. In the Group Name field, enter a Group Name that you configured in
the SNMPv3 Access Table.
See “Creating an Access Table” on page 221.
There are four default values for this field that are reserved for
SNMPv1 and SNMPv2c implementations:
ˆ defaultV1GroupReadOnly