Allied Telesis AT-S62 - Manual (Page 117)

AT-S62 Management Software Web Browser Interface User’s Guide
Section II: Advanced Operations 117
The System Utilities tab is shown in Figure 28.
Figure 28. System Utilities Tab
Note
The top portion of the tab resets the switch to its factory default
settings. For instructions, refer to “Returning the AT-S62 Software to
the Factory Default Values” on page 49.
4. In the TFTP Server IP Address field, enter the IP address of the
network node with the TFTP server software.
5. In the TFTP Operation field, click Download.
6. In the TFTP Remote Filename field, enter the name of the file on the
TFTP server to download onto the switch.
7. In the TFTP Local Filename field, enter a name for the file for when it is
stored in the switch’s file system. The name can be from 1 to 32
alphanumeric characters. Spaces are allowed, but special characters
(e.g., /, \, #, and %) should not be used. If you are downloading the
AT-S62 image file, enter “ats62.img” as the filename.
8. In the TFTP File Type, select one of the following:
ˆ Image - Select this option to download a new AT-S62 image file.
This option stores the image in the switch’s application block,
making it the active AT-S62 image on the switch.