Allied Telesis AT-S62 - Manual (Page 257)

AT-S62 Management Software Web Browser Interface User’s Guide
Section III: SNMPv3 257
Modifying an
SNMPv3
Community
Table Entry
To modify an entry in the SNMPv3 Community Table, perform the
following procedure.
1. From the Home Page, select Configuration.
2. Select the Mgmt Protocols menu selection.
3. Select the SNMP Tab.
The SNMP Tab is shown in Figure 58 on page 206.
4. In the SNMPv3 section of the page, click the circle next to Configure
Community Table. Then click Configure at the bottom of the page.
The SNMPv3 Community Table Page is shown in Figure 80 on page
254.
5. Click the circle next to the SNMPv3 Community Table entry that you
want to change. Then click Modify.
The Modify SNMPv3 Community Table Page is shown in Figure 82.
Figure 82. Modify SNMPv3 Community Table Page
6. In the Community Name field, enter a Community Name of up to 64-
alphanumeric characters.
The value of the Community Name parameter acts as a password for
the SNMPv3 Community Table entry. This parameter is case sensitive.
Note
Allied Telesyn recommends that you select SNMP Community
Names carefully to ensure these names are known only to
authorized personnel.