Allied Telesis AT-S62 - Manual (Page 256)

Chapter 19: SNMPv3
256 Section III: SNMPv3
NonVolatile
Select this storage type if you want the ability to save an entry in the
SNMPv3 Community Table to the configuration file. After making
changes to an SNMPv3 Community Table entry with a NonVolatile
storage type, the Save Config menu selection appears.
Note
The Row Status parameter is a read-only field in the Web interface.
The Active value indicates the SNMPv3 Community Table entry
takes effect immediately.
11. Click Apply to update the SNMPv3 Community Table.
12. To save your changes, select the Save Config menu selection.
Deleting an
SNMPv3
Community
Table Entry
To delete an entry in the SNMPv3 Community Table, perform the following
procedure.
1. From the Home Page, select Configuration.
2. Select the Mgmt Protocols menu selection.
3. Select the SNMP Tab.
The SNMP Tab is shown in Figure 58 on page 206.
4. In the SNMPv3 section of the page, click the circle next to Configure
Community Table. Then click Configure at the bottom of the page.
The SNMPv3 Community Table Page is shown in Figure 80 on page
254.
5. Click the circle next to the SNMPv3 Community Table entry that you
want to delete. Then click Remove.
A warning message is displayed. Click OK to remove the SNMPv3
Community Table entry.
6. To save your changes, select the Save Config menu selection.