Allied Telesis AT-S62 - Manual (Page 114)

Chapter 9: File System
114 Section II: Advanced Operations
Attributes - This can be any of the following:
ˆ Normal
ˆ Read Only
ˆ Hidden
ˆ System
ˆ Volume
ˆ Directory
ˆ Archive
ˆ Invalid
4. To change the active boot configuration file, enter the name of the file
in the Default Configuration Field field. The file must already exist in
the file system. You can select a configuration file that you created on
the switch or that you downloaded onto the switch from another switch.
Note
You cannot create a new boot configuration file from the web
browser interface.
5. Click Apply.
The switch checks to be sure that the file exists and then displays the
file name with “Exists” following it, meaning that the switch found the
file. The file has now been designated as the new active boot
configuration file for the switch.
If the switch could not locate the file, the name of the previous boot
configuration file is displayed again. Repeat steps 4 and 5, being sure
to enter the name correctly.
6. Do one of the following:
ˆ To configure the switch using the parameter settings in this boot
configuration file, do not select Save Config. Instead, reset or
power cycle the switch.
ˆ To overwrite the settings in the configuration file with the switch’s
current operating settings, select Save Config.