Allied Telesis AT-S62 - Manual (Page 312)

Chapter 22: GARP VLAN Registration Protocol
312 Section V: Virtual LANs
Configuring GVRP
To configure the GVRP parameters, perform the following procedure:
1. From the Home Page, select Configuration.
2. Select the Layer 2 menu selection.
3. Select the GVRP tab.
The GVRP tab is shown in Figure 103.
Figure 103. GVRP Tab (Configuring)
The GVRP tab is not shown if MSTP is enabled on the switch.
The Default button returns all GVRP parameter settings to their default
values.
4. Configure the following parameters:
Enable GVRP
Click this box to enable or disable GVRP. A check in the box enables
GVRP. No check disables GVRP. The default setting is disabled.
Leave Time
Sets the duration of the Leave Period timer. The range is from 30
to180 centiseconds and the default is 60.