Allied Telesis AT-S62 - Manual (Page 227)

AT-S62 Management Software Web Browser Interface User’s Guide
Section III: SNMPv3 227
Modifying an
Access Table
Entry
To modify an entry in the SNMPv3 Access Table, perform the following
procedure.
1. From the Home Page, select Configuration.
2. Select the Mgmt Protocols menu selection.
3. Select the SNMP Tab.
The SNMP Tab is shown in Figure 58 on page 206.
4. In the SNMPv3 section of the page, click the circle next to Configure
Access Table. Then click Configure at the bottom of the page.
The SNMPv3 Access Table Page is shown in Figure 65 on page 222.
5. Display the Access Table entry that you want to change.
Click Next or Previous to display an entry.
6. Click Modify.
The Modify SNMPv3 Access Page is shown in Figure 67.
Figure 67. Modify SNMPv3 Access Page
Note
The Context Prefix field is a read-only field. The Context Prefix field
is always set to null.
7. In the Read View Name field, enter a value that you configured with
the View Name parameter in the View Table.