Allied Telesis AT-S62 - Manual (Page 159)

AT-S62 Management Software Web Browser Interface User’s Guide
Section II: Advanced Operations 159
The Modify Flow Group page is shown in Figure 42.
Figure 42. Modify Flow Group Page
5. Configure the following parameters as necessary:
ID
Specifies the ID number for this flow group. You cannot change this
value.
DSCP
Specifies a replacement value to write into the DSCP (TOS) field of the
packets. The range is 0 to 63. A new DSCP value can be set at all
three levels: flow group, traffic class, and policy. A DSCP value
specified in a flow group overrides a DSCP value specified at the traffic
class or policy level.
Remark Priority
Replaces the user priority value in the packets with the new value
specified in the Priority parameter.
Description
Specifies the flow group description. A description can be up to 15
alphanumeric characters, including spaces.
Priority (802.1p)
Specifies a new user priority value for the packets. The range is 0 to 7.
If you specify a new user priority value here and in Traffic Class, the
value here overrides the value in Traffic Class. If you want the packets
to retain the new value when they exit the switch, change Remark
Priority to Yes.