Allied Telesis AT-S62 - Manual (Page 266)

Chapter 19: SNMPv3
266 Section III: SNMPv3
Displaying Target
Parameters Table
Entries
To display entries in the SNMPv3 Target Parameters Table, perform the
following procedure.
1. From the Home Page, select Monitoring.
2. Select the Mgmt Protocols menu selection.
3. Select the SNMP Tab.
4. From the SNMP Monitoring Tab, click the circle next to the View
Target Parameters Table.
5. Click View at the bottom of the page.
The Monitoring, SNMPv3 Target Parameters Table Page is shown in
Figure 88.
Figure 89. Monitoring, SNMPv3 Target Parameters Table Page