Allied Telesis AT-S62 - Manual (Page 246)

Chapter 19: SNMPv3
246 Section III: SNMPv3
Configuring the SNMPv3 Target Parameters Table
You can create, delete, and modify an SNMPv3 Target Parameters Table
entry. See the following procedures:
ˆ “Creating a Target Address Table Entry” on page 239
ˆ “Deleting a Target Address Table Entry” on page 242
ˆ “Modifying Target Address Table Entry” on page 243
For reference information about the SNMPv3 Target Parameters Table,
see “Configuring the SNMPv3 Target Parameters Table” on page 246.
Creating a Target
Parameters Table
Entry
To create an entry in the SNMPv3 Target Parameters Table, perform the
following procedure.
1. From the Home Page, select Configuration.
2. Select the Mgmt Protocols menu selection.
3. Select the SNMP Tab. The SNMP Tab is shown in Figure 58 on page
206.
4. In the SNMPv3 section of the page, click the circle next to Configure
Target Parameters Table. Then click Configure at the bottom of the
page.
The SNMPv3 Target Parameters Table Page is shown in Figure 77.
Figure 77. SNMPv3 Target Parameters Table Page